Alpha Microsystems Eagle 250 Manuel de service Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
Eagle 250 Service Manual Page 17
Rev. 01
1.
Since the AM-138 is attached to the panel, you need to detach it from the computer’s back panel
before removing the mounting panel. Remove the screws near the UPS status port and parallel
port on the back panel.
2.
Remove the two Phillips-head screws attaching the mounting panel to the chassis.
Notice how the panel is positioned over the two alignment tabs on the bottom of the chassis.
When you reinstall the panel, you must make sure it is properly positioned over both tabs; if not,
you won’t be able to reinstall the two screws.
3.
Move the panel forward slightly so the AM-138 connectors clear the back panel, then tilt the top
of the panel away from the chassis and remove it.
4.
With the mounting panel out of the way, you can access both sides of the peripheral mounting
bracket and have complete access to all six drive bays.
5.
To install a peripheral, simply slide it into one of the available bays and install the four screws
(two on each side) that hold the device in place.
6.
Don't forget to attach the appropriate power and interface cables to your new peripheral.
7.
After you have completed your peripheral installation, you can reinstall the side mounting panel
and AM-138 by reversing the steps above.
The mounting panel is an integral part of the chassis assembly. With it removed, the chassis may
shift slightly, either forward or backward. To reinstall the panel, you can realign the chassis by
placing one hand on the top of the chassis and applying pressure either forward or backward.
With the chassis properly aligned, the panel will slide into place.
Additional Documentation
Each peripheral device sold by Alpha Micro is covered by its own set of installation instructions. The
installation instructions include information on jumper settings, termination, and cabling. Before
installing a peripheral, make sure you read the documentation pertaining to the device.
If the documentation was not included with your peripheral device, it is probably contained on the
AlphaCD which is distributed to all Alpha Micro Value Added Resellers on a periodic basis, and on our
Web site at www.amos-online.com.
Vue de la page 19
1 2 ... 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire